Відео

Interesting topic I’ve been painting for awhile I grew up finishing the walls first then the frames the way you are saying.. I have tried both methods i understand finishing the frames first then the walls because of the edge it’s quicker.. but in saying that there’s a risk of damaging the frames etc.. Also if done in oil based paint you wanna make sure it’s completely dried before finishing the walls

Do i need to primer seal acrylic render before using exterior self priming paint ? Or can i just thin down 1st cost of exterior self priming paint?

Thanks so much

Thank you so much ✌️ ashamed of myself for trying with a knife 🗡️😅😅😅

Does that work with varnish?

Man is 32.

OR dry brush the edges to blend and fade.

Your sir, are a champion

Why not spray?

You sand primer?

Aaaaaa

This is very helpful. I only wish I watched it before I painted my living room!

And what if there was no wide enough gap for the roller between the outlet and the side wall? What's the plan then? Great video, clearly explained.

thank u for that tricks . i'm gonna try it. hat is what i am searching for

Painting in a zoo?

some videos say the first coat should be diluted with water but that didn't happen here and I don't know if it's really necessary or not.

8 foot

Thank you

Simple and clean, exactly the top that I needed! Thank you 🙏🏼

Very well spoken , Aussie accent , great video , great advice

Can’t understand you sorry

I always end up with the paint on the cieling.. I can't seem to get crisp edges. I've tried tape, no tape . Insist can't seem to win..but I have an angle brush..guess I'll try again.. sigh.. thx

How comes you don’t roll it off after? Or will the second roll cover any brush marks?

Unbelievable,we now need a vid to show us how to put it back on fs

So far the best wall paint video . Thanks

Do you have any tips for how to avoid getting run-off when painting? I have to keep sanding back because all the paint keeps dripping down the wall as it sets, when I paint it it looks fine.. come back 5 mins later and its all running down the wall lol. Edit: Also I keep finding the paint is ripping when I go to do the layoff roll - again any suggestions would be appreciated.

The way your glossing the door frame is the right way old school by doing that way your glossing everything inside instead of walking in and out.. a lot of painters now usually do start behind the door and gloss the whole frame inside and outside and continue with the top and side as all one piece so you don’t miss a section

Thank you for sharing this skill.

Nice work mate have watched most of your videos Awesome work have subscribed cheers

can i just use a garbage back to seal both roller and paint tray?

Which roller do you use? Brand? Thank you for reply 💪

Thankyou for teaching me how to paint I have just painted my sliding door and all the other videos have helped me paint my duplex I am in Australia this has been so helpful and I have to say it is turning out really good thanks for sharing 😊

Good

Thanks Sir

Thanks Sir Greetings From West Africa Ghana 🇬🇭

Does this work if you do not have an Australian accent? I could always cheat and buy a can of Fosters lager.

Thank you So Much ! Extremely Helpful!!!

That’s a lot of time and expense when you have plenty of containers available that are free. When I was in the trade I had 2 x 10 litre buckets with lids in my van. One was for dirty rollers that needed to be washed for another colour and the other one had cleaned rollers that were stored in water. The dirty roller was stored in water in the dirty bucket and the cleaned ones were ready for use after they had been spun out with a roller spinner. The dirty rollers were cleaned at home with a small plastic cylindrical device that fitted onto a hose and could clean a roller from black in less than 5 listers of water. I went overseas for a couple of years and stayed for 10 and came back and checked the rollers. They were as good as the day I left them

Great video, thanks! Which brush do you prefer to use for this particular job, could you recommend one available in Australia?

The real way is to take the door off of the hinges so it is not half assed like this guy .

How do you clean paint off the brush when it says "cleans up with soap and water" but the paintbrush still has paint in it? Also do you have a video for how to load the roller...my paint was on one side, it was a huge struggle to put the paint evenly on the roller brush.

What about a purdy parrot roller?

Show how to do in 9 inch r ok this all they guve us this morons

I normally masonry big brush first as it gets the holes better , and then roll over then , makes it look like no holes at all ❤

what kind of detergent do you use it ?

Honestly never thought of a spray gun for painting the cladding. Always assumed it was for cars lol

I would like to touch up the walls in my rental apartment- what’s the best paint for me to buy - I saw base A and Base B online and got confused

I used a small roller but when dry it looks differnet( noticeable)

To close the issue once &for all.......just make an agreement which will be written as like fulfilling the more refunded payable demand instead of making the gurantee of whatever the opposite party wanted as their written doc.

Genius!